ok
Direktori : /proc/thread-self/root/proc/self/root/proc/self/root/lib/firmware/ath9k_htc/ |
Current File : //proc/thread-self/root/proc/self/root/proc/self/root/lib/firmware/ath9k_htc/htc_7010-1.4.0.fw |
_wmi_cmd_rsp __adf_nbuf_free __adf_nbuf_realloc_headroom __adf_nbuf_realloc_tailroom __adf_nbuf_expand __adf_nbuf_trim_tail __adf_nbuf_copy __adf_nbuf_unshare __adf_nbuf_get_priv __adf_nbuf_create_frm_frag __adf_nbuf_split_to_frag P P( �n� PD PH �n� P� P` �p� P� Px �p� P� P� �p� P� P� �p P� P� �p P� P �p P$ P, �s� PH PL �sx Pd Pl �qL P� P� �vt P� P� �n� P� P� �r, P� P� �o P P �o` P� P� usb_reg_out_patch �c �i �o �u �{ �� �� �� ��wmi_cmd_rsp ath_uapsd_processtriggers ath_enable_aggr_tgt ath_vap_create_tgt ath_setcurmode dispatch_magpie_sys_cmds tgt_HTCRecvMessageHandler ath_tgt_send_beacon tgt_ServiceConnect ath_desc_alloc ath_descdma_setup HTCControlSvcProcessMsg WMIRecvMessageHandler ��� �� ��� ��� ��H ��t ��\ ��� ��, �� ��H ��� ��h ��X ��x �� ��� 2 K P S U W X Zath_buf_toggle ath_tgt_tx_sched_aggr 6 4 l N � h � �D �� �� 4 l h � �D ��8��`��8ath_tgt_tx_prepare ath_tx_buf_alloc ath_tgt_txq_add_ucast ath_tgt_send_mgt ath_tgt_handle_normal ath_tgt_handle_aggr ath_tgt_tx_form_aggr ath_tgt_tx_comp_aggr A_WDT_INIT() ==>WDT reset<== ==>warm start<== ==>cold start<== ALLOCRAM start 0x%x size %d Enable Tx Stream mode: 0x%x USB mode: 0x%x Tgt running ======= Apply MISC Assert patch exception_reset exception reset-phase 1 exception reset-phase 2 do TX/RX swap Cold reboot initiated. <Exception>Tgt Drv send an event 44332211 to Host Drv Fatal exception (%d): pc=0x%x badvaddr=0x%x dump area=0x%x epc1=0x%x, epc2=0x%x, epc3=0x%x, epc4=0x%x 0x%08x, 0x%08x, 0x%08x, <WrongEPID>Tgt Drv send an event 44332212 to Host Drv HTC Hdr EndpointID = %d, anblen = %d HTC Hder : %2x-%2x-%2x-%2x-%2x-%2x-%2x-%2x-%2x-%2x-%2x-%2x init_htc_handle = 0x%8x Return WMI Command buffer Return Data buffer HTC Hdr EndpointID = %d, anblen = %d HTC Hder : %2x-%2x-%2x-%2x-%2x-%2x-%2x-%2x EP1-Tx-Data with Wrong Htc Header Endpoint ID, WAR free this buffer EP1-Tx-Data > Free this buffer successfully EP4-WMI-Cmd with Wrong Htc Header Endpoint ID, WAR free this buffer EP4-WMI-Cmd > Free this buffer successfully %s: buffer allocation for event_id %x failed! Assertion failed! %s [+++Magpie_init] [+++VBUF_init(%d)] Error! Incorrect format. %s %s Magpie Debugger: [D.0.0.0.3] Feb 20 2015 22:01:00 ===Command Listing=== %s %s memcmp(buf1, buf2, len) = %d %06x: %04x %c STR STRH STRB %s : %s Error! bad address 0x%08x. LDR LDRH read intr mask [0x%08x] intr on [0x%08x] timer - intr [0x%08x] off ==>set cb to %d seconds intr read - read the interrenable status intr timer on/off/tick - timer attach on/off/ticks rst reseting... boot Last BOOT is wdt normal boot loop doing the wdt reseting... (wdt tick: 0x%08x... noloop event THIS IS USB COMMAND que usb que - dump descriptor queue usb fw on/off - enable/disable write fw download to ram ram >